Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Northeast Philadelphia Homeowners
If your chimney is pulling away from the house, shedding brick faces onto the sidewalk, or staining the ceiling near the flue, you’re looking at repair work, not another cleaning. Chimney repair in Northeast Philadelphia usually means masonry that has absorbed too many freeze-thaw cycles, or a flashing seam that stopped shedding water years ago. Our technicians have up to 13 years of experience with the full system, from the firebox to the crown. We can often see a Northeast Philadelphia chimney the same day you call. Reach us at (855) 658-4023 and we’ll set a free estimate.
What Our Chimney Repair Service Includes
Mortar Repointing
Repointing is grinding out failed mortar joints and packing in fresh mortar that bonds to the old brick without crushing it. You need it when joints have receded, gone sandy, or started dropping grit onto the roof, because water gets behind a soft joint and freezes there. In Northeast Philadelphia we cut the joints to a consistent depth rather than smearing mortar over the surface, so the repair holds through the next winter.

Spalling Brick Repair
Spalling is the face of a brick flaking or popping off, usually after moisture gets inside and expands as it freezes. It matters because each spalled brick leaves a weaker shoulder for the next one to fail against, and the chimney’s outer wythe gets thinner over time. We replace the damaged units with brick matched to the existing chimney and re-bed them properly, rather than capping the damage with a patch that traps water.

Chimney Waterproofing
Waterproofing is a breathable sealer applied to the masonry so rain beads off while vapor still escapes from inside. You need it when the brick drinks water and the chimney stays dark for days after a storm, which is common on the older housing stock around Northeast Philadelphia. We apply it after any repointing or brick replacement is done, never over a failing joint, because sealer locks in a problem it can’t fix.

Flashing Repair
Flashing is the metal where the chimney meets the roof, and it’s the single most common source of the water stains people call us about. It needs attention when the sealant along the edge has cracked, the metal has pulled loose, or you can see daylight or staining at the roof line. We rebuild the flashing layers into the masonry and the shingles so water runs off the way it should, which is a job a general roofer and a chimney specialist usually have to split.
Chimney Rebuilding
Rebuilding is taking a chimney down to solid masonry and building it back up, typically from the roofline upward when the top courses have gone soft. You need it when the crown and upper stack have lost so much material that repointing would be cosmetic. We check the structure above and below the roof line first, then rebuild the damaged section with a new crown so the finished stack sheds water from the start.
Tuckpointing
Tuckpointing is the finer version of repointing, where joints are filled and finished to a clean, uniform profile that matches the original brickwork. It’s the right call when the mortar is still sound but the appearance has gone ragged, or when earlier patch work left the joints looking uneven. We match the mortar color and tool the joints consistently so the repair disappears into the chimney instead of standing out.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
HeatShield is the product we turn to for chimney liner resurfacing, and it’s designed specifically for deteriorating clay tile liners that can no longer be sealed with a simple sweep. The application takes specific product training to get the coating thickness right, and that’s the difference between a liner that lasts and one that cracks away in a season. We also work with DuraFlex flexible stainless steel liners, which let us reline an older Northeast Philadelphia flue without tearing the chimney apart. If your flue is too far gone for resurfacing, a DuraFlex retrofit is usually the answer.
Gelco and Copperfield round out the material side of our repair work, and knowing how each one behaves on a real chimney matters more than the label on the box. We service chimneys that already have these products installed and know where each tends to wear first, whether that’s at the top plate, the crown line, or the connection at the firebox. Whether your chimney has HeatShield, DuraFlex, Gelco, Copperfield, or any other make, we can help.
Signs You Need Chimney Repair Right Now
- Crumbling mortar between the bricks. If joints are receding or you’re finding grit on the roof or ground, water is already getting in. Repointing now is far cheaper than rebuilding later.
- Flaking or falling brick faces. Spalling means the brick itself is breaking down, not just the mortar. Each freeze-thaw cycle takes more of the face with it, so this one gets worse on its own.
- Water stains on the ceiling or chimney breast. Interior staining almost always traces back to flashing or a failed crown. It’s worth finding the source before the framing behind it takes on water.
- A chimney that leans or separates from the house. A visible gap at the roofline is a structural concern, and it should be looked at rather than watched. We check it rather than guess.
- Rust on the damper or a smoky smell in the room. That points to moisture inside the flue or a liner that’s no longer sealed. It’s a reason to get the system inspected before the heating season, not after.
Our Chimney Repair Process – Step by Step
- 1
We look before we quote. A repair estimate starts with eyes on the actual chimney, from the roof and from inside the firebox. We check the crown, the flashing, the brick faces, and the flue before we say a word about price.
- 2
We run a camera down the flue. A video inspection shows what the liner looks like from the inside, and you see the same footage we do. That’s how we tell the difference between a liner that needs resurfacing and one that’s still sound.
- 3
We write down what we found. You get a written scope with the repair items listed, so nothing gets added mid-job without your say. If part of the work can safely wait, we tell you that too.
- 4
We do the masonry and the flue work together. Repointing, brick replacement, flashing, and liner work are handled as one job from the firebox to the crown, so you’re not coordinating a mason and a sweep separately.
- 5
We check it before we leave. The finished repair gets a look at the joints, the crown, and the flashing, and we show you photos of the completed work. If something needs a second visit, we say so plainly.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Northeast Philadelphia?
A typical repointing job on a Northeast Philadelphia chimney runs $600 to $1,800 depending on how many faces are accessible and how deep the joints have gone. Spalling brick replacement usually lands between $500 and $1,500, and flashing repair sits around $400 to $900 because it involves both the masonry and the roof line. Chimney rebuilding from the roofline up is the larger job, generally $3,000 to $8,000 depending on height and how much of the stack has to come down. Waterproofing after the masonry work is done typically adds $300 to $700.
What moves the number: chimney height, roof pitch and access, how much of the mortar has actually failed versus how much looks bad, and whether the repair is masonry only or includes liner work. You avoid overpaying by asking for the repair items in writing and by getting the camera inspection before anyone recommends a liner. Our estimates are free, and the written estimate sets the final price, so there’s no surprise on the invoice. If you’ve been told you need thousands in liner work, ask to see the camera footage first.
| Repair | Typical Estimate Range |
|---|---|
| Mortar repointing | $600 – $1,800 |
| Spalling brick replacement | $500 – $1,500 |
| Flashing repair | $400 – $900 |
| Waterproofing (after masonry) | $300 – $700 |
| Chimney rebuild from roofline | $3,000 – $8,000 |
Chimney Repair Near Northeast Philadelphia – Our Service Area
We cover Northeast Philadelphia and the neighborhoods and towns around it, including Bustleton, Rhawnhurst, Olney, Rockledge, Abington, Lower Moreland, Bensalem, Feasterville, Trevose, and Lower Southampton. Most of these are a short drive from our area, so we can often get a free estimate out the same day you call. If you’re nearby and need chimney repair or a look at a chimney in Lower Moreland, the same crew handles it.
Serving Northeast Philadelphia, PA – Our Local Coverage Area
We serve Northeast Philadelphia and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Northeast Philadelphia
Chimney repair is fixing the parts of the chimney that have failed or are failing, from the masonry on the outside to the liner and firebox inside. It covers repointing, brick replacement, flashing, waterproofing, rebuilding, and liner resurfacing or replacement when the flue itself has gone bad. It’s different from a cleaning, which removes soot and creosote but doesn’t fix anything structural. If you’re not sure which you need, a camera inspection settles it, and we can look at it as part of your estimate.
Most repointing and flashing repairs are finished in a single visit, while a brick replacement or a rebuild from the roofline can run two to several days depending on height and access. The written estimate gives you the expected timeframe before work starts, so you’re not guessing. We work around the weather where the job allows, since mortar and waterproofing need dry conditions to cure properly. For smaller jobs, we’re often able to get you on the schedule quickly.
Most repairs here fall between $400 and $1,800, with repointing and flashing at the lower end and rebuilding or liner work pushing higher. The written estimate sets the final price, and we give it to you before any work begins. Call (855) 658-4023 for an exact quote – estimates are free. If some of the work can safely wait, we’ll tell you that too rather than bundling it in.
Yes, we work with HeatShield for liner resurfacing and DuraFlex flexible stainless liners for full relines, and we know where each one wears and how it should be applied. HeatShield requires proper application training to hold up, and we follow the process rather than a quick coat. If your existing liner is one of these, we’ll inspect it and show you what we see on camera. You’ll know whether resurfacing is enough or a replacement is the honest answer.
Yes, same-day repair is often available when you call and we have an opening. We answer 24/7, and our dispatch runs 7am to 7pm, Sunday through Friday, with Saturday closed. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 658-4023 and we’ll find you a time that works.
Warranty terms depend on the specific repair and the materials used, and we’ll set out what applies to your job in the written estimate rather than promising a blanket guarantee. Repointing, waterproofing, and liner work each carry different expectations, and we’ll tell you which one covers your repair. Ask us directly when we’re out for the estimate and we’ll put it in writing.
Clear access to the fireplace opening, move anything breakable away from the hearth, and let us know where the roof access point is if you have one. If there’s a damper or a gas log set, mention it on the call so we bring the right tools. You don’t need to do anything to the chimney itself. The rest is on us, and we’ll walk you through what we’re doing as we go.
Schedule Your Chimney Repair Service in Northeast Philadelphia Today
Crumbling joints and bad flashing get worse through the winter, so it’s worth getting an honest look now. Call (855) 658-4023 for a free, no-obligation estimate on chimney repair in Northeast Philadelphia. We answer 24/7, fast dispatch runs 7am to 7pm, Sunday through Friday. We’ll show you the problem on camera and tell you what actually needs fixing.
Written by the team at Chimney Sweep Northeast Philadelphia.